Work Harness

BLACK WEAR LEATHER - 1 1/2 x 1 3/4"

These 32mm (1 1/4") straps are made to suit ZGB saddles. They loop onto the saddle dee, and are designed to secure the shaft loops/tugs in place. ...

Black Wear Leathers - 1" - 1 1/4", 1 1/2"-1 3/4", or 2"

This is designed for use with the ZGB Combined Breastplate and Traces, and enables the connection of the traces to the vehicle. This model is used...

Trace carry straps are used to prevent the traces from hanging too low, thus helping to prevent the horse from getting their leg over the trace. T...

Trace carry straps are used to prevent the traces from hanging too low, thus helping to prevent the horse from getting their leg over the trace. T...

Pole straps are used in Pairs or Team driving where a suspended pole is employed. They are attached to the Dee on the front of the breastplate and ...

The coupling strap is used in Team harness to link the breastplates of the two lead horses together. This model is supplied as standard in Cob &am...

Used to prevent the harness saddle from moving forward, this newly designed model sits flatter against the horse's back and features a new, softer ...

This lies over the horse's rump and attaches at each end to the carriage shafts. It helps to prevent horses bucking when hitched to the carriage, p...

Stainless Steel Fittings - Leather Brass Fittings - Leather

Draft Size Kicking Strap - Nylon, SS Hardware

Leather Trace Extenders - Pair - 1 1/2" - Plain. Brass hardware.

Leather Tie Strap -  Draft Size - Plain 1" X 80" - Brass Hardware

Draft Size- Leather Britchen Body

Plain Leather Bit Strap Draft Size Bit Straps are 13" Long Horse Size Bit Straps are 11" Long

The Hip Strap (shown in red on the diagram) supports the breeching. These are replacement straps, designed to suit the Classic Complete Breeching

Traces are what attach the horse to the vehicle. They are buckled into the end of the breastplate and attached at the other end to the carriage tre...

LEATHER CRUPPER WITH FORKS - DRAFT SIZE - Plain. Brass or Stainless Steel hardware. Folded leather.

LEATHER CRUPPER WITH FORKS - DRAFT SIZE - Plain. Brass or Stainless Steel hardware. Stuffed with flax seed.

These 25mm (1")straps are made to suit Classic harness saddles. They loop onto the saddle dee, and are designed to secure the shaft loops/tugs in p...

False Martingales are designed to keep the breastplate in place. It is fitted by attaching the stainless steel clip to the small dee at the center ...

The Brake Strap (shown in blue on the diagram) is designed to help support and balance the breastplate. Measuring 25mm (1") wide, this model is su...